750W 1100W 2200W 4000W Swimming Pool Water Pump Spa Bath Pump
||Port Size (inch/mm)
- Silent operation
- Can resist chemical in swimming pool
- Pool motor with 48 frame
- Overload protection
- Huge pro-filter for less cleaning maintenance
- Arrange drain device of water pump
- Suitable for all types and sizes pools, in-ground spas
1) Magnificent flow rate and lift, the core energy of water circulating, 2~3m suction lift
2) Engineering plastic body, the pump can be effectively protected under bad weather,
long service life;
3) Seiko manufacturing, low noise during the pump working time;
4) Free-tool filter cover design, easy to maintenance;
5) IP55 protection level, with None-leaky design;
6) German technology IBC bearing, 100% copper wire motor, 24 hours running.
7) Anti-rust cast-aluminum motor cover, fast heat dissipation; PPO plastic steel material
impeller, resist high temperature and corrosion
8) Silicone sealing ring cover all watering section, enhance pump sealing system
9) CE certificated, reliable and safety
Pump Use Precautions:
1. If the pump has any small faults, remember not to let it work. If the filler of the pump shaft is worn out, it should be added in time. If the pump is used continuously, it will leak. The direct effect of this is that the motor consumes more energy and can damage the impeller.
2. If the pump has a strong vibration during use, be sure to stop and check what is the cause, otherwise it will cause damage to the pump.
3. When the bottom valve of the pump leaks, some people will fill it into the inlet pipe of the pump with dry soil and flush it to the bottom of the valve. This is not desirable. Because when the dry soil is put into the water inlet pipe, when the water pump starts to work, the dry soil will enter the pump, which will damage the water pump impeller and the bearing, which shortens the service life of the water pump. When the bottom valve leaks, it must be repaired. If it is serious, it needs to be replaced.
4, the pump must pay attention to maintenance after use, for example, when the pump is used up, the water in the pump should be cleaned, it is best to remove the water pipe and then rinse with water.
5, the tape on the pump should also be removed, then rinse with water and dry in the light, do not put the tape in a dark and humid place. The tape of the pump must not be stained with oil, and do not apply some sticky material to the tape.