High Efficient Circulation Spa Water Pump Big Flow Rate For Swimming Pool

High Head Big Flow Rate Swimming Pool High Efficient Circulation Spa Water Pump

Description

Anti-rust crust can stop water penetrating theengine. Enough power, high head, big fluxand high efficient circulation. Smaller noiseand run quietly. The pump cover bears high airtight preventing the leaking. The main partof the pump is made of special plastic which isanti-high or low temperature So it is durable .Convenient to handle, easy to maintain, withthe supplyingof spare parts.

Electric pump over-current components using high-strength,engineering plastics, with high-quality wear-resistant,Good motor cooling for the motor,Within the cooling, low noise standard motor.Complete separation of water and the axis, safe and reliable.Motors with high temperature bearings, long operating life,with reliability and durability.Optional pneumatic switch, to ensure ease of use.

Features:

* Suitable for the swimming pool 100m3
* Max flow rate of 110m3/h
* Suitable for salt, chorine, in-ground and above-ground pools
* Corrosion-resistant marine grade cast iron motor housing
* Chemical-resistant thermoplastic filter cartridge tank body
* Durable construction
* Removable lint and hair trap/ filter
* Transparent twist on cover
* Built-in thermal protection
* Instruction manual
* One-year warranty

Specifications:

* Rated power: 11000/15HP
* Max. Pump rate: 110m3/h
* Max. Head: 22m
* Max. Grain/ particle size: 2.5mm
* Max. Temperature of water handled: 80 degree Celsius
* Inner & outer pipe diameter: 90mm
* Length of cable: 1.2m
* Noise Level: <65dB
* Weight: 10kg

The Pump Use Skills:

When the swimming pool pump has too much head lift, it will affect the filtration accuracy, cause human injury, overload overheating, burn out the motor, vaporize cavitation, damage the pump and piping system. For the newly designed swimming pool and spa, it is necessary to take various factors into consideration and carry out the head calculation according to the actual project. It cannot be taken for granted. For the already running system, check the readings of the pump front vacuum gauge and the post-pump pressure gauge to determine the actual working system head. For the major problems, do the following:

· Replace the pump and select a pump that is similar to the actual working lift and flow.

· Cut and reduce the outer diameter of the impeller to reduce the rated lift of the pump so that it is close to the actual working head of the pump

· Before the pump starts, close the valve on the water outlet pipe (the valve is located in front of the pump sand tank), start the motor, thicken the bracket swimming pool wholesale, and gradually open the valve after the pump runs smoothly. By controlling the opening of the outlet valve, the pump flow is reduced, thereby reducing pump load and heat generation.

The Circulating Water Pump In The Standard Use Precautions:

The choice of swimming pool circulating water pump should meet the following requirements:

(1) The rated flow of the pump should not be less than the calculated circulating water flow of the pool water purification treatment system to ensure the required flow rate of the pool water cycle;

(2) The lift of the pump shall not be less than the calculated value of the geometric height of the water supply, the resistance of the circulating purification treatment system equipment and the piping system and the required outflow head of the pool inlet multiplied by 1.10;

(3) The pump should be a special frequency conversion speed regulating pump for swimming pool with high efficiency, energy saving, corrosion resistance and low noise;

(4) The circulating water pump of the pressure filter should not be less than 2 sets, and the standby pump should be set up and can be alternately operated with the working pump;

(5) The backwashing water pump of the quartz sand filter should be designed in parallel with the working mode of the pool water circulating pump working pump and the standby pump, and adjust the circulating water pump working condition according to the flow and head check required for the backwashing of a single filter. parameter.