4HP 5HP Pumps For Swimming Pool 0,50 hp Aquarium Water Pump Swimming Pool Pumps
||Port Size (inch/mm)
1. Excellent Flow rate suitable for spas and pools up to 2000 litres
2. Suitable for spas including Salt, Chorine, Inground and Above Ground
3. Corrosion Resistant and Chemical-resistant thermoplastic body
4. Tough durable construction for longer lasting life
5. Built-In Thermal Protection
6. Instruction manual for ease of installation and use.
7. Anti spin-off impeller.
8. A large see-through strainer, super-size debris basket.
9. Special design shockproof basement
10. Good quality and modern design
11. Low operation noise
12. Single or three phase
13. Anodized motor body
14. Huge pro-filter for less cleaning maintenance
Release all air from fitter and piping system: see filter owner manual
In a flooded suction system (water source higher than pump),
pump will prime.
it self when suction and discharge valves are opened.
If pump is not in a flooded suction system, unscrew and remove cap
cover; fill cap and pump with water.
Clean and inspect Ring; re-install on trap cover.
Replace cap cover on cap turn clockwise to tighten cover.
During the use of the pool pump, the technical parameters used to measure the performance of the pool pump are flow, suction stroke, head, shaft power, water power, efficiency, etc.
That is, the water absorption height of the swimming pool pump. Refers to the vertical distance from the center of the pump body to the horizontal level of the water source. When the water flow is pumped by the vacuum in the pump body, the allowable suction stroke is generally not more than 7.5 meters.
That is, the lifting height of the swimming pool pump. Refers to the value of the energy increase per unit weight of water after passing through the pool pump. Generally, the height difference between the inlet and outlet water level of the pumping station is called the actual head; plus the head loss of the pumping station pipeline and its accessories (such as the bottom valve, elbow, gate valve, etc.) is called the total head. The lift on the swimming pool pump refers to the lift of the pool pump when the efficiency is high at a certain speed, which is the sum of the actual lift and the lost lift.
Refers to the amount of water that the swimming pool pump delivers per unit time, also known as the amount of water delivered. Commonly used flow units are liters per second, cubic meters per second, cubic meters per hour, kilograms per second, tons per hour, and the like.
4. Axis power.
Refers to the power delivered by the power machine to the swimming pool pump shaft, ie the input power of the swimming pool pump.